Glory Heat Resisting Paint


Is a modified alkyd based coating recommended for application on metallic surfaces, which may be subjected to moderate surface temperatures. It can be applied on metal chimney stacks, metal surfaces adjacent to furnaces etc. It resists up to a maximum of 220 degrees centigrade. Can be applied directly to the surface without priming.

Surface Preparation

Surface to be painted must be clean and in good condition, free of any rust, grease, oil or other surface contaminants. Wire brush and or acid etch the surface to remove all traces of rust, sand down to enhance adhesion to substrate.


Thin with Glory Heat Resisting Thinner.


Apply by brush or spray.

Drying Time

Touch dry in 30 minutes, hard dry overnight.

Spread Rate

About 10 to 12 meters square per liter.

Equipment Cleaner

Clean with Glory Heat Resisting Thinner.

Colour Range

Red Oxide, Grey Aps can be supply on request.

Packing Sizes

1 liter, 4 liter and 20 liter.


Store in a cool dry place, with adequate ventilation. Keep away from any source of ignition.

Health & Safety

• Flammable, keep away from sources of ignition.
• Avoid smoking when working on material.
• Use in a well ventilated area.
• For spray application, wear suitable respiratory gear.

Disclaimer: Statements and recommendations made herein are based on tests believed to be reliable. However, no guarantee for their accuracy or completeness is made. Products are sold without warranties or conditions expressed or implied. Purchasers must make their own test to determine the suitability of our products for their particular purposes.