Glory 2 Pack Epoxy Floor Paint

Description

A high performance two component epoxy based floor paint cured by an epoxy hardener. It provides maximum resistance to chemical attack, abrasion and water penetration. It is recommended for use on all types of floor surfaces. It is the ideal coating for application in chemical plants, factories and other high traffic areas.

Characteristics

• Outstanding durability
• Chemical resistant
• Resistant to abrasion
• Very good hardness
• Resistance to pedestrian and vehicular traffic

Surface Preparation

Remove all old floor paint if previously coated with ordinarly Floor Paint by use of Glory Paint Remover. Remove all traces of rust (where applicable) with Glory Rust Remover.

Mixing

Mix 4 parts of the Glory Epoxy Floor Paint with 1 part of the Epoxy Hardener. Thin to the required application viscosity by use of Glory Epoxy Thinner. Let stand for 15 minutes before application.

Application

Apply 2 to 3 coats at 16 hours intervals.

Finish

Gloss, Satin.

Drying Time

Touch dry in 2 to 4 hours, hard dry in 16 hours. Recoatable overnight. Maximum hardness attained after 7 days.

Spread Rate

Approximately 10 square meters per liter.

Equipment Cleaner

Glory 2 Pack Epoxy Thinner.

Colour Range

Red Oxide, Grey Aps can be supply on request.

Storage

Store in a cool, dry and well ventilated place. Away from any possible source of ignition.

Health & Safety

• Flammable, keep away from sources of ignition.
• Use in a well ventilated area.
• Do not smoke when working on material.
• Use suitable respiratory gear for spray application.
• Keep out of reach of children.

Disclaimer: Statements and recommendations made herein are based on tests believed to be reliable. However, no guarantee for their accuracy or completeness is made. Products are sold without warranties or conditions expressed or implied. Purchasers must make their own test to determine the suitability of our products for their particular purposes.