Glory 2 Pack Epoxy Enamel

Description

A high performance two component epoxy enamel cured by an epoxy hardener. It provides maximum protection against corrosion, chemical attack, abrasion and water penetration. It is recommended for use on prepared metal (primed) wood and concrete surfaces. It is an ideal coating for application in chemical plants, factories and other high traffic areas.

Characteristics

• Outstanding durability
• Chemical resistant
• Resistant to abrasion
• Very good hardness

Surface Preparation

Remove all old paint by using Glory Paint Remover, where repainting is being undertaken. Remove all traces of rust with Glory Rust Remover and rinse thoroughly with clean water. Apply one coat of the appropriate Glory Primer.

Mixing

Mix 4 parts of the Glory Epoxy Paint with 1 part of the polyamide hardener. Thin to the required application viscosity by use of Glory Epoxy Thinner. Let stand for 15 minutes before application.

Application

By brush, roller or spray. Apply 2 to 3 coats at 16 hours intervals.

Finish

Gloss, Satin and Matt.

Drying Time

Touch dry in 2 to 4 hours, hard dry in 16 hours. Recoatable overnight. Maximum hardness attained after 7 days.

Spread Rate

Approximately 10 square meters per liter.

Equipment Cleaner

Glory 2 Pack Epoxy Thinner.

Colour Range

White available ex-stock, Aps can be supplied on request

Storage

Store in a cool, dry and well ventilated place away from any possible source of ignition.

Health & Safety

• Flammable, keep away from sources of ignition.
• Use in a well ventilated area.
• Do not smoke when working on material
• Use suitable respiratory gear for spray application.
• Keep out of reach of children.

Disclaimer: statements and recommendations made herein are based on tests believed to be reliable. However, no guarantee for their accuracy or completeness is made. Products are sold without warranties or conditions expressed or implied. Purchasers must make their own test to determine the suitability of our products for their particular purposes.